Uploaded clips featuring 9ball

Posted on Jul 8, 2010
Owner's Notes
some zz fiddlin' on the crunch channel. used a 10 band EQ as a mid boost switched on about 3:15, and then off at about 3:41. switched to the neck p/u (PAF joe) while the boost was on.
Posted on May 27, 2010
Owner's Notes
lead channel both volumes(master and channel) on 5 gain on 4 - guitar's volume turned up and down at the beginning and end. switched to the neck pick up for a few seconds about half way through, mostly the bridge pick up.
Posted on May 24, 2010
Owner's Notes
wanted to make a clip of the clean channel. most of the rythm track is the RG with both pickups on full. near the end i switch to the PAFjoe in the neck for a few seconds. dimarzio mo'joe bridge/PAF joe neck pickups.
the lead track is the crunch channel.
Posted on May 22, 2010
Owner's Notes
tried a limiter this time in mastering in an attempt to tame the speaker distortion - still sounds a little off from in person. may be because of the 3 band compressor that's still turned on in mastering. still learning - anyways this is the lead channel with a set of blackouts in a mahogany guitar. near the end around 3:00 i think i switched it back over to the crunch channel just to compare but the gain was still kind of high on crunch.
master volume here is only at 5, which is just opening up, channel volumes at 5, and the gain on lead is 5, crunch is just over 6.
Posted on May 15, 2010
Owner's Notes
one take/one track complete with mistakes. plugged straight in no effects/ nothing in the FX loop/no mastering effects. dimarzio mo'joe/PAF joe pickups.
Posted on Jan 18, 2008
Owner's Notes
quick bluesy clip with seDV8-R w/JB- crunch channel
Posted on Jan 18, 2008
Owner's Notes
small clip with dv8-rse w/jb volume rolled off then turned up on crunch channel-
sonic stomp/hotplate used
Community Bulletin Board
comments and feedback

1 2
Page 1 of 2